Do you know how to disassemble the bearing? Follow the Wholesale Inch16 Series Bearing editor for a brief understanding.
Removal of the outer ring To remove the outer ring with interference fit, set several screws for the outer ring extrusion screw on the circumference of the outer casing in advance, and tighten the screw evenly while disassembling. These screw holes are usually covered with blind plugs, separable bearings such as tapered roller bearings, and several notches are set on the shoulders of the housing. Use spacers to remove them with a press, or gently tap to remove.
The dismantling of the inner ring can be the easiest to pull out with a press. At this time, pay attention to let the inner ring bear its pulling force. Furthermore, the pull-out clamps shown are mostly used, and no matter which kind of clamps, they must be firmly clamped on the side of the inner ring. For this reason, it is necessary to consider the size of the shaft shoulder, or study the machining of the upper groove at the shoulder, so as to use the drawing jig.

The disassembly of the inner ring of the large bearing adopts the hydraulic method. Oil pressure is applied through the oil hole provided in the bearing to make it easy to pull out. For bearings with large widths, the hydraulic method is used in combination with the pulling jig for disassembly.
The inner ring disassembly of cylindrical roller bearings can use the induction heating method. A method of drawing by heating the part in a short time to expand the inner ring. Where a large number of these bearing inner rings need to be installed, the induction heating method is also used.
The above is the editor of Wholesale Inch16 Series Bearing: a brief introduction to the knowledge about the disassembly method of the bearing.